Using of printed antennas to evaluate the permittivity of materials

Sergey V. Bukharov; Leonid A. Filins’kyy

doi:10.1109/ICATT.2017.7972631

Authors

Sergey V. Bukharov Oles Honchar Dnipro National University, Ukraine https://orcid.org/0000-0001-8714-1241
Leonid A. Filins’kyy Oles Honchar Dnipro National University, Ukraine https://orcid.org/0000-0002-9487-773X

DOI:

https://doi.org/10.1109/ICATT.2017.7972631

Keywords:

dielectric permittivity, calibration dependence, printed antenna, patch antenna, method of moments

Abstract

The paper considers the results of modeling the calibration dependence for the dielectric permittivity sensor in the form of a patch antenna in a contact measurement method. The problem is solved by a numerical method in the FEKO simulation environment.

References

S. Bankov and A. Kurushin, Evaluation of Radiated Structures Using FEKO [in Russian]. Moscow: RODNIK, 2008. 246 р.

Kashif Saeed, Muhammad F. Shafique, Matthew B. Byrne, and Ian C. Hunter, “Planar microwave sensors for complex permittivity characterization of materials and their applications,” in Applied Measurement Systems [ed. by Zahurul Haq]. Intech, 2012. 390 p. DOI: http://doi.org/10.5772/36302.

Mirjana Bogosanovich, “Microstrip patch sensor for measurement of the permittivity of homogeneous dielectric materials, ” IEEE Trans. Instrum. Meas., vol. 49, no. 5, рр. 1144-1148, Oct. 2000, DOI: http://doi.org/10.1109/19.872944.

Using of printed antennas to evaluate the permittivity of materials

Authors

DOI:

Keywords:

Abstract

References

Published

Issue

Section

Subscription

Information