The measurement of a power flow in two-mode waveguide with using galvanomagnetic transducers

Authors

  • P. V. Ivkin National Technical University of Ukraine "Kyiv Polytechnic Institute", Ukraine

DOI:

https://doi.org/10.1109/ICATT.1999.1236261

Abstract

The most widespread method of power measuring in multimode waveguide supposes using of multiprobe section [1, 2]. Such a section contains gauges of electrical field in shape of thin wire probes. The probes are situated in several reference and measuring sections. It is possible to measure amplitudes and phases of wave composition with use of such a section. The power of each wave is calculated from the obtained amplitudes of fields.

References

Burlachuk, V.V.; Geyvandov, A.N.; Daniluk, V.S. Automatized measuring-calculating system for the multimode measuring in the microwave waveguide sections. Trans. of III Republican Sci. and Tech. Conf. on The Methods and Means of Measuring in Area of Electromagnetic Compatibility, 1991, Vinnitsa, Ukraine. Vinnitsa, 1991, p. 126-133.

Taub, J.J. A new technique for multimode power measurement. IRE Trans. Microwave Theory and Techniques, 1962, Vol. 10, p. 496-505.

Vuntesmeri, V.S. Ferromagnetic-film galvanomagnetic transducers of microwave power flow. Izv. VUZ. Radioelektronika, 1980, Vol. XXIII, No. 3, p. 28-34.

Nikolskiy, V.V.; Nikolskaya, T.I. Electromagnetics and Propagation of Radiowaves. Mocsow: Science, 1989, pp. 231–233.

ICATT 1999 cover

Published

1999-09-14

Issue

1999: ICATT’99 - Proc. of III Int. Conf. on Antenna Theory and Techniques

Section

Antenna measurements