An improving of energy radiation characteristics of an corner reflector antenna with Franklin antenna feed

Authors

  • A. V. Seleznyov National Technical University of Ukraine "Kyiv Polytechnic Institute", Ukraine

DOI:

https://doi.org/10.1109/ICATT.1999.1236219

Abstract

There are two main requirements during antennas system researches and development – maximum adaptability to manufacture (for minimal cost) and required values of electrical parameters. There are contradictions between these requirements, therefore it is necessary to find acceptable technical solution. Thus it is necessary to prefer the completely defined characteristics depending on area of application, prospective consumers etc. For many practical tasks the modifications of the antennas system with a corner reflector will be optimal.

References

Drabkin, A.A. Antenna-Feeder Devices. Moscow: Energija, 1974, 467 p. [in Russian].

Marcov, G.T.; Sazonov, D.M. Antennas. Moscow: Energija, 1975, 564 p. [in Russian].

Ayzenberg, G.Z. VHF Antennas, Vol. 1, 2. Moscow: Sviaz, 1977, 354 p. [in Russian].

Guk, M.S.; Molochcov, U.B. Design of Antenna-Feeder Devices. Moscow-Leningrad: Energija, 1966, 365 p. [in Russian].

Shalyakin, A.I. About one way of increasing gain of corner reflector antenna. Radiotekhnika, 1985, No. 2, p. 81-82.

ICATT 1999 cover

Published

1999-09-14

Issue

1999: ICATT’99 - Proc. of III Int. Conf. on Antenna Theory and Techniques

Section

LGA, printed antennas